In the previous article, we introduced how to select transfer membranes and filter paper for Western Blot. This article will further provide detailed procedures and key precautions in Western Blot to help obtain clear and stable bands.
Material Preparation
- Prepare the following materials before transfer
- Transfer membrane (PVDF or NC)
- Transfer filter paper
- Sponge pads
- Transfer buffer (recommended to be pre-cooled at 4 ℃)
- Post-electrophoresis gel
Precautions: Before use, soak the PVDF membrane in methanol for 10-30 s to activate until uniformly semi-transparent, then place it into transfer buffer for equilibration and fully wetted.
Transfer Sandwich Setup
After electrophoresis, carefully remove the whole gel, trim off the stacking gel, rinse the separating gel with pure water, and equilibrate the separating gel in transfer buffer for about 5 min. Then assemble the transfer "sandwich":
From negative electrode to positive electrode, the order is sponge pad, transfer filter paper, separating gel, transfer membrane, transfer filter paper, sponge pad. The thickness of the filter paper should be appropriate so that the transfer clamp can be moderately tightened.

Precautions: All materials need to be fully soaked with buffer, and press down on the stack with a small roller to remove any bubbles.
Transfer
Western Blot transfer methods include wet transfer and semi-dry transfer, among which wet transfer is commonly used in laboratories.

Precautions: Semi-dry transfer is more sensitive to operating conditions; improper parameter control can easily affect transfer results.
Wet Transfer Recommendations
During wet transfer, time and current can be appropriately adjusted according to the molecular weight of the target protein. It is recommended to perform the entire process in an cooling box to avoid overheating of the buffer affecting transfer efficiency. Pre-stained protein marker can be used to evaluate transfer performance.

Post-Transfer Steps
After transfer completed, staining, blocking, and antibody incubation are usually performed, followed by development and protein quantification.
- Ponceau S staining (optional) can be used for rapid evaluation and bands can be observed after staining for 1-5 min.
- Blocking is typically conducted with 5% skim milk powder or 5% BSA at room temperature for 1–1.5 h.
- Antibody incubation involves 2 parts: primary antibody incubates at RT for 1–2 h or at 4°C overnight; secondary antibody incubates at RT for 1 h, with antibody concentrations following manufacturer recommendations or optimized conditions.
Wash the membrane with TBST for 3×10 min after each step, followed by detection and quantitative analysis of the target protein.
Precautions
- Avoid any bubbles when assembling the transfer cassette.
- Confirm the order of the membrane and the gel, avoiding protein transfer in the wrong direction.
- Keep the membrane wet after activation to prevent affecting protein binding capacity.
- Perform wet transfer in an cooling box to prevent buffer overheating from affecting transfer efficiency and band clarity.
- Adjust transfer time and current based on the protein molecular weight, avoiding insufficient or excessive transfer.
Storage of Transfer Membrane
- Short-term storage in TBST or PBS at 4°C.
- Long-term storage involves washing, air-drying, being sealed and protected from light.
Transfer and antibody incubation are key steps before Western Blot detection, and the operational standardization directly affects quantitative results. By selecting the proper transfer method, optimizing operation details, and standardizing blocking and antibody incubation steps, band clarity and result stability can be effectively improved. In practice, it is recommended to iteratively optimize experimental conditions based on the characteristics of the target protein to achieve more ideal detection results.